42 Daysailer

SPECIFICATIONS

HULL
• Vinylester resin throughout
• Single-piece Core-Cell® cored fiberglass molding
• Core phased out in way of all thru-hulls, drive leg, rudder port & centreline
• Molded keel sump with increased laminate
• Awlgrip® painted topsides & boot stripe
• Epoxy bottom barrier coat
• Owner-specified bottom paint
• Externally fastened 8134 lb. cast lead ballast

DECK
• Single piece Core-Cell® cored fiberglass molding with non-skid pattern on all working surfaces 
• Core phased out in way of all deck fittings
• Awlgrip® painted deck & non-skid
• Lazarette storage in aft deck
• (2) large storage lockers in cockpit
• Varnished teak cabin nosing
• Varnished teak caprail

DECK HARDWARE WINCHES
• All winches chromed & self-tailing
• (2) primary electric cockpit winches Lewmar #48
• (1) cabintop control line winch, Lewmar #30
• (2) winch handles, 10” with lock-in
• 12 volt dual direction Lewmar windlass
• 3” foam upholstered cockpit cushions

TRACKS, LEADS, BLOCKS
• All deck hardware Harken or Lewmar
• Deck blocks at spar for halyard reefs & control lines
• (2) two-sheave organizers
• (2) inboard genoa tracks
• (2) opening low-lead sheet cars
• (2) large snatch blocks
• (2) double sheave foot blocks

CLEATS & CHOCKS
• (6) 10” stainless steel flush mount mooring cleats
• (6) custom chrome bronze chocks set into caprail
• Cabintop cleats as required
• Line stoppers as required

SAILS
• North - fully battened main
• 100% Genoa
• multi-purpose spinnaker

SPARS & RIGGING
• Awlgrip® aluminium mast & boom
• Fractional rig with swept double spreaders 
• (3) internal halyards, internal outhaul & reefing lines
• Boom with welded ends, four internal sheaves, & adjustable outhaul car
• Hydraulic boom vang
• Hydraulic backstay
• Headsail furler with drum and control line below decks
• All standing rigging Navtec® solid rod discontinuous rigging with turnbuckles & toggles at deck
• Custom stainless steel chainplates
• All rope running rigging color coded
• (1) mainsheet
• (2) genoa sheets
• (1) main halyard with shackle
• (1) genoa halyard with swivel snap shackle

STEERING
• Balanced fiberglass foam-filled rudder with stainless steel shaft & stiffeners
• 44” diameter stainless steel wheel with teak wrapping
• 6” Ritchie® compass with stainless steel cap
• Stainless steel emergency tiller

ENGINE & DRIVE SYSTEM
• Yanmar 30hp saildrive with folding two-blade propeller
• 26 US gallon fuel tank with vent
• Racor® fuel filter
• Engine room sound insulation
• Blower engine room ventilation
• Hinged engine access
• Stainless steel thru-transom exhaust
• Coast Guard approved exhaust hoses
• Water lift muffler

NAVIGATION
• 2 multi displays for wind, speed, depth
• VHF radio in cockpit
• Raymarine® GPS/Chart plotter

ACCOMMODATIONS
• All interior joiner work & trim gloss varnished
• Varnished teak & holly sole
• Table with folding leaves in salon
• Settees convertible to berths
• Hanging locker forward
• 5” foam upholstered cushions in main cabin 
• All latches, hinges, catches & pulls bright 
chrome or stainless steel
• Corian® counter tops in galley & head

REFRIGERATION
• 12 volt DC refrigeration
• Molded fiberglass box with 4” foam insulation

PLUMBING
• Pressure water with hot & cold faucets in head & galley
• 6 gallon water heater with 110V & engine heat exchange
• Foot pump for salt water/icebox in galley
• 2 water tanks, 60 U.S. gallons total, with level gauges 
• Cockpit shower
• Marine manual toilet
• 18 gallon holding tank with overboard discharge & 12 volt macerator
• All seacocks Marelon®
• Rule® 2000 electric bilge pump with float switch 
• #10 Whale® “Gusher” manual bilge pump mounted in cockpit

ELECTRICAL
• All wiring sized & colour coded to ABYC specs.
• Navigation lights on masthead, stern light on aft deck
• Steaming, foredeck, masthead & spreader lights on mast
• Light on compass
• (1) DS115 & (2) 4D gel cell batteries
• (2) explosion-proof master battery selection switches
• 12V DC custom distribution panel with 30 amp service
• Double-pole shore power main breaker
• Voltage meter, polarity indicator
• 110 volt 30 amp shore power with 50’ cord
• 110 volt outlets in galley, head & dinette
• 1500 watt inverter/charger
• Microwave